The Atlas Model XT-200 Welding Positioner is ideally suited for those short-to-long run welding jobs requiring rotary fixturing and positioning. This compact but husky unit will help boost your production on all those hard to handle jobs requiring circular welding ( small spheres and pressure vessels, flange to pipe, pipe to pipe, etc.. )
The Model 200 will handle properly balanced loads of up to 200 pounds when in the horizontal position. The heavy duty grounding circuit allows use of stick electrode, MIG or TIG welding processes.
The Model XT-100 is powered by DC permanent magnet gearhead motors. Motor speed is controlled by a solid state variable speed controller, which is a voltage control device. When voltage isreduced the motors turn slower. At the low end of the motors speed ( approximately 20% of the top speed ), torque tends to fall off. The speed ranges listed below reflect optimum torque levels. The machines will operate at considerable slower speeds, but may not have the "lugging power" to turn loads that are near maximum weight, or are out of balance.
Some of the motor specifications may be changed ( except r.p.m.'s ) due to an upgraded motor.
|Capacity:||200 lbs. properly balanced with table in horizontal position.|
|Motor:||DC Permanent Magnet|
|Power Requirement:||115V AC 60 cycle @ 1.3 Amps. 5'3" conductor cord with plug supplied.|
|Bearings:||Turntable shaft supported by 2 Oilite bushings to carry radial loads and 2 ball bearing to carry axial loads.|
|Motor Overload Protection:||2 Amp fuse on front panel.|
|Table Rotation:||Forward-Off-Reverse, controlled by toggle switch on front panel.|
|Table Tilt:||130o forward, 15o backward, with worm and spur gear adjustment and locking device.|
|Speed Control:||Solid state electronic feedback control maintains constant torque and speed from 0 - 80% of full speed. Full speed obtained by complete clockwise rotation of front panel mounted dial.|
|Start / Stop Control:||Rheostat-type foot switch with 6' cord.|
|Welding Current Grounding Circuit:||200 Amps.|
|Dimensions:||Height 9 1/2", Width 10 1/2", Front to Back 12 3/4".|
|Construction:||Heavy duty steel construction throughout. Baked enamel exterior finish for easy cleaning and long lasting good looks.|
|Net Weight:||41 pounds.|
|Shipping Weight:||35 pounds.|